Fit For Toyota Highlander 2009-14 Carbon Fiber Gear Box Shift & Cup Holder Panel. (Never Been Used or Installed). Made in an ISO 9001 facility to ensure good quality. Easy Installing, 3M glue on the back (and paste).Paste surfaces should be kept absolutely clean and dry, general cleaning can be used no fiber shedding cloth dipped in 50% alcohol, isopropyl alcohol, acetone or toluene solution to scrub the surface by solvent cleaning solvent must be completely play behind can be pasted. Product paste, paste products product must be installed on the site required to adjust, determine the location of product installation, then tore off the red film paste. Operation should avoid finger contact with the rubber surface, the product Paste to be with the beat, in order to ensure full access to plastic surface and wetting. Products and paste parts not in contact with water, and larger dust within the required 24 hours before they achieve the best adhesion. If you have any comments our products or suggestions, please tell us, We will take your advice be changed to R & D. We will reply within 10 hours you encounter problems. The item "Fit For Toyota Highlander 2009-14 Carbon Fiber Gear Box Shift & Cup Holder Panel" is in sale since Monday, October 25, 2021. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Interior Parts & Accessories\Trim". The seller is "auto-parts-hot" and is located in guangzhou. This item can be shipped worldwide.